Download DMC5400 - Leadshine

Hardware Manual for the DMC5400 Motion Controller
1. The PUL/DIR control signal is too weak causing by too large current limit resistor in
series with the driver.
Erratic motor motion or
inaccuracy positioning
2. The PUL/DIR control signal is interfered.
3. Wrong motor connection.
4. Motor broken or something wrong with motor coil.
5. Current setting of the motor driver is too small.
6. The DMC5400 failure; contact Leadshine for help or repair.
1. The encoder signal is not a TTL signal. Use an encoder whose signals are TTL
compatible.
2. Encoder wiring is wrong. Wiring encoder correctly and fix wires firmly.
3. Encoder has not been powered correctly. Check the power supply for encoder.
Can’t count correctly.
4. The feedback signals are corrupted by noise signal (s). Please increase noise
immunity of feedback signals, such as using shielded cable(s) and good grounding.
5. Called a wrong function or right function but with wrong parameter(s). Please call
the correct function with correct parameter(s).
6. Encoder failure.
7. The DMC5400 failure; contact Leadshine for help or repair.
1. Wrong wiring. Wiring correctly and fix wires firmly.
Fail to capture counter
2. Called a wrong function or right function but with wrong parameter(s). Please call
value or can but with
the correct function with correct parameter(s).
poor reliability.
3. Trigger signal is a dither signal.
4. The DMC5400 failure; contact Leadshine for help or repair.
1. Wrong wiring. Wiring correctly and fix wires firmly.
2. Called a wrong function or right function but with wrong parameter(s). Please call
Fail
to
read
input
signal(s).
the correct function with correct parameter(s).
3. Input device(s)/sensor(s) failure.
4. Input signal is interfered.
5. The DMC5400 failure; contact Leadshine for help or repair.
1. Wrong wiring. Wiring correctly and fix wires firmly.
Fail to control output
2. Called a wrong function or right function but with wrong parameter(s). Please call
port(s).
the correct function with correct parameter(s).
3. The DMC5400 failure; contact Leadshine for help or repair.
Tel: +086 0755-26434369
Email: [email protected]
Page: 34/36
Web Site: www.leadshine.com