1
Download Intecal
Transcript
Issue 2 Parameters and units for Variables (For Intecal-Advanced only) Table A-2 gives a list of the available Parameters and Units that you can use when you set up a Variable in a Calibration System (Chapter 5, Figure 5-6). Table A-2: Parameters and units for Variables Parameter Available units Area cm2 in2 mi2 ft2 km2 mm2 ha m2 yd2 A Amps Current/Current AC mA Density Frequency Mass Pressure g/cm mAmps 3 g/m3 oz/gal kg/cm3 kg/m3 lb/ft3 lb/in3 GHz Hz kHz MHz g kg mg oz ton ug atm in H2O @ 4°C mm H2O @ 4°C bar in H2O @ 60°C mmH2O cm H2O @ 4°C inH2O mmHg cm H2O kg/cm2 MPa cm Hg @ 0°C kg/m2 Pa cm Hg kPa psi ftH2O lb/ft2 tonf/ft2 hPa mbar tonf/in2 in H2O @ 0°C mH2O Torr in H2O @ 20°C mHg in H2O @ 25°C Resistance MOhm Ohm Temperature °C °R Celsius °F °K Fahrenheit Kelvin Voltage Voltage DC A-2 mV V mVolts Volts mV V Volts Volts DC Volts DC Parameters and units
