1
Download 4Motion Device Driver User Manual
Transcript
Chapter 3 - Managing a Single Device ASN-GW Parameter Description Source Port Start The minimum value of source TCP/UDP port range. The default is 0. Source Port Stop The maximum value of source TCP/UDP port range. The default is 65535. Destination Port Start The minimum value of destination TCP/UDP port range. The default is 0. Destination Port Stop The maximum value of destination TCP/UDP port range. The default is 65535. DSCP Start The minimum value of DSCP range. The default is 0. DSCP Stop The maximum value of DSCP range. The default is 63. Filter Action Action to be performed on packets that match the rule: Pass, Drop, HTTP Redirect. The default is Pass. HTTP Redirect is applicable only if Direction is Uplink. If set to HTTP Redirect then HTTP Redirect Address (see Profiles Table above) must be defined. The following buttons are available below the table: 3.7.5 Button Description Add Adds a new entry to the table, allowing to configure new rule’s parameter. Delete Deletes the selected entry (or several selected entries) from the table. SFA Page The Service Flow Authorization (SFA) functionality handles creation/maintenance of pre-provisioned service flows for MS. It maps the AAA parameters (service profile name) received from the AAA server to pre-configured WiMAX-specific QoS parameters in the NPU. The SFA page enables configuring and maintaining service flows, including configuring Packet Header Suppression (PHS) rules, multiple service profiles with multiple service flows, and classification rules. The SFA page includes the following tabs: PHS Rules Tab Classification Rules Tab In addition, the Service Profile sub-node of the SFA node enables creating new service profiles and viewing/modifying service profiles. 3.7.5.1 PHS Rules Tab The PHS Rules tab enables defining rules for Packet Header Suppression (PHS). PHS rules are provisioned on a per-service profile name basis. 4Motion and MC ASN-GW DD User Manual 113
