Download AutoCut - Autometrix

Transcript
Cable 2
pin 5-11
Cable 1
pins 4-12
Cable 3
pin 12-18
2. Identify the three cables that enter the y axis e-chain.
3. Carefully cut each of the wires in the three cables, about 1
inch long, as you did at the Cutting Head end.
4. Cut any cable ties required to release those cables.
5. Gently pull these three cables out of the e-chain.
Carriage End Connections
Replacing the New Y cables:
1. One at a time, feed the three cables through the access port,
into the e-chain, and out the other end.
2. Reattach the e-chain at the cutting head, and attach the air
lines to the correct fittings.
3. Select the cable with the correct markings and, matching the
color code, replace each wire, one at a time.
4. Be careful to not pinch the wire insulation in the terminal
strip connection.
5. Make sure that all cables are clear of moving parts and
install cable ties as needed.
6. Power up the machine and press “Find Home” to verify
success.
42