Download vScan User Manual
Transcript
3 User Controls/Connections Locating Modes: Power mode Radio mode 33kHz Active 131kHz Active Sonde mode Metal cover detection mode 3.1.3Warning/Alerts Warnings or alerts can be indicated by four different methods: 1. Audio - an audible warning sound will be emitted. 2. Vibe - a vibration device situated in the handle will activate. 3. Visual - an alert icon will replace the battery icon. 4. Shutdown – the vScan can be configured to shut down if the management or user decides that is the most appropriate course of action (examples – if self-test and calibration verification fails, or a “rental” period ends). NOTE The vScan will continue to operate in a warning/alert condition unless configured to “shut down”. If an overload condition is triggered the bar graph will also flash. How warnings/alarms communicate their message is user configurable using MyvScan desktop application. 3.1.3.1 Shallow Line Alert The shallow line alert will be triggered when a shallow line is detected. 3.1.3.2 Swing Alert The swing alert will trigger if the angle of swing exceeds 30 degrees from the vertical. No alarm will be activated if the angle is more than 65 degrees from the vertical as it will be assumed that the locator is not in use at this time. ™ Page 11 of 35 [email protected] | 13309 Beach Ave. Marina del Rey, CA 90292 | wctproducts.com | Phone: 800-WCT-PROD (800-928-7763) or 310-822-5212 | Fax: 310-306-9343