Download CE EMC TEST REPORT

Transcript
4.2.3 ATEST PROCEDURE
a. The EUT was placed 0.4 meters from the conducting wall of the shielded room
and connected to the power mains through a line impedance stabilization
network (LISN). Other support units were connected to the power mains through
another LISN.
b. Voltage at the measurement port of the ISN was detected, the reading was
corrected by adding the voltage division factor of the ISN, and was compared to
the voltage limits.
c. The disturbance levels and the frequencies of at least six highest disturbances
were recorded from each telecommunication port which comprises the EUT.
4.2.4 DEVIATION FROM TEST STANDARD
No deviation
l
: The test Configuration was defined by the applicant requirement.
cording to the Note 3 of Table 4 of CISPR 22:1997/EN 55022:1998, a relaxation of 10 dB over tz.
For B equipment, a relaxation of 10 dB over the referency range of 6 MHz to 30 MHz is allowed
for high speed services having significant spectral density in this ba
Report No.: CE941006H04B
Reference No.: 941219H04
21
Report Format Version 2.0.4