Download Manual - Adm21

KOM200 User’s Manual 200911
Chapter 4: Network Connection
KOM200 support two types of networking, point to point and single fiber ring. The figures are as follows：
1． Point to Point
Figure 11 Point to Point Diagram
2． Single Fiber Ring
When composing a single fiber ring using KOM200, the device needs to be set as Master or Slave. If P1
and P2 are connected, the device is Master; If P1 and P2 are not connected, the device becomes Slave.
Figure 12 KOM200 Single Fiber Ring Diagram
Attention:
1) Do not place the equipments close to water sources or damp places；
2) Please keep optical fiber plugs and sockets clean. Please cover the interface when it’s not use.
13