Download DMD2050 - ImageEvent

User Interfaces
DMD2050 Universal Satellite Modem
HI STAB VCO ADJUST
{0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
LARGEST HB GAP
Used for factory test only.
SOFT RESET
{ENTER}
Resets the modem.
IF BOARD (menu)
Indicates the Radyne
Assembly.
part number for the IF Board
AGC/CTRL/VALUE
{0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
I OFFSET
Used for factory test only.
Q OFFSET
Used for factory test only.
IF RX LVL OFFSET
Used for factory test only.
LB RX LVL OFFSET
Used for factory test only.
POWER SOURCE
Used for factory test only.
TERR INTFC BRD
Indicates the Radyne
Interface Assembly.
part number for the Terrestrial
CODEC BOARD (menu)
Indicates the Radyne part number for the Codec Board.
TPC FPGA IMAGE
Used for factory test only.
RS FPGA IMAGE
Used for factory test only.
TPC CODEC IMAGE
Used for factory test only.
FEATURES (menu)
5012.2840.2417
{____.____.____}
Allows the user to install purchased feature
upgrades (see Appendix A).
Whether or not the feature has been upgraded, or if the
feature requires a hardware upgrade (contact the
Radyne Customer Service Department).
UPGRADE LIST (menu) The following menu screens display the following:
10 MBPS, 20 MBPS, 52 MBPS (The highest option installed will hide the
lower rates.)
RXIF
RXLBAND
4-36
TM110 - Rev. 1.3