Download installing and using lantastic for windows 95

58
To change the settings on a modem server, follow these steps:
1. Go to the computer that has the modem attached. From the
LANtastic Custom Control Panel, Manage Servers page, click
Share Modem. The Manage Shared Modem window appears.
2. If you want to let others use the modem, make sure the Share
my modem on the network check box is checked. Click it to
remove the check mark if you don’t want anyone to be able to
use the modem over the network. This computer will then
have to access its own modem from the physical port (see step
4).
3. The computer’s name appears in the Modem Name field. This
is the name everyone on the network will see in the list of
available network modems. If you’d rather have the modem
type (brand name) or the phone number the modem uses
displayed, you can type in those changes here.
4. In the Communication Port field, select the port to which the
modem is physically attached. Either choose one of the
standard port settings (COM1 through COM4), or click
Specify port settings and type in the modem’s I/O Base
address and Interrupt Request (IRQ) setting. You may have to
specify these settings, for example, if:
■
The port doesn’t use the
COM1
IRQ 4
COM2
IRQ 3
COM3
IRQ 4
COM4
IRQ 3
following standard settings:
I/O Base 3F8
I/O Base 2F8
I/O Base 3E8
I/O Base 2E8
■
Your modem documentation says you must use settings
that are different from the standard ones shown above (as
is sometimes the case with internal modems).
5. Click OK to save your changes, then repeat these steps on all
computers on the network that have modems attached, if you
want to check or change them.
INSTALLING AND USING LANTASTIC FOR WINDOWS 95 TRIAL VERSION SOFTWARE