Download Infinity User Manual

13
Infinity V95 August 2014 Update Notes
Modified Values
Calibration table changes that haven't been committed to flash memory are highlighted as shown
below. Conditions that will reset the display are as follows:
1. Manually committing changes through the Target > Commit modifications menu command
2. Manually committing changes using the hot key combination [Ctrl Shift C]
3. Opening and closing the Setup Wizard. Note the Setup Wizard automatically commits ALL
changes to memory every time it is closed.
4. Turning the ignition switch off when the tuning preference Key Off Commit is selected
Advanced Tuning
© 2015 AEM Performance Electronics