Download 2N SmartCOM User Manual

2N® SmartCOM Control Panel Use
7.3
Click on a selected terminal on the right to display the Terminal Details window
including the name, serial number, hardware revision number and count of available
relays and digital and analogue inputs. Notes are also displayed on the terminal if
available.
If you are a user, you can select a virtual port for terminal connection. The Virtual
ports can fully be administered by the user; refer to the Virtual Ports subsection
below. If you select an unoccupied port, the port will be marked „in use‟ signalling to
the other users that the port is engaged in the configuration.
If you have the appropriate user right, you can also set the communication
parameters for the selected port including the transmission rate and others even if the
terminal is connected and used for data transmission. Select the parameters using the
combo boxes and the changes will be effective the moment they are saved.
Click on the Info button in on-line terminals to display details on the connected
terminal, relay control and values measured on analogue and digital inputs.
Figure 7.5
Terminals Menu
Terminal Details
The Terminal Details include the following data: GSM module IMEI (International
Mobile Equipment Identity), name and number of the GSM provider at which your
2N® SmartCOM is registered, signal intensity in dBm, ICCID (Integrated Circuit Card
ID) and IMSI (International Mobile Subscriber Identity). The In roaming parameter
indicates whether the SIM card is used in the roaming mode. Moreover, the
2N® SmartCOM terminal serial number and current firmware as well as information
(firmware version, manufacturer and type) on the GSM module used are displayed.
You can switch the relay contacts in the Relays section. The Digital Inputs displays
the value currently measured at the input and transformed to a logic value (0 or 1) as
calibrated. The Analogue Inputs displays the values measured at analogue inputs.
The Calibrated and Absolute parameters include the percentage against the calibrated
range and the absolute value against the A/D converter range respectively.
Refer to Subs. 3.3, Input Circuits, for more details on input circuit function and
calibration.
62