Download STMicroelectronics ST7MDT6-EPB2/US Datasheet

ST7MDT6-EMU2B Emulator User Manual
4
EMULATOR FEATURES
4.1
Main Features of the ST7 HDS2 Emulator series
4 - Emulator Features
The features described below are common to all ST7 HDS2 emulators:
4.2
•
Real-time emulation capability (internal frequency from internal 0.5 MHz up to
8 MHz).
•
Full memory emulation (up to 64 KB).
•
Real-time trace with 3 event conditions allowing selective recording.
•
Hardware breakpoint capability on instruction Fetch.
•
Hardware breakpoint capability on address.
•
Breakpoint capability on invalid address access.
•
Breakpoint capability if trace is full.
•
1K x 32-bit real-time trace (address, data, ctrl).
•
6 different modes to configure trace access by combining 3 event conditions.
•
Selective trace recording capability.
•
2-Trigger output capability.
•
Can use as an external clock source either the on-probe oscillator, or an
external source via the front panel input.
•
4 probe inputs to display application signals in the trace.
Specific Features of the ST7MDT6-EMU2B
The features described below are specific to the ST7MDT6-Active Probe:
•
Clock source selection.
•
The application power supply follower allows this emulator to run with
application VCC from 3.5 V to 5.5 V. When the probe is not connected to an
application board or if the application board isn't powered (application VCC<
3.5 V), the VCC default value is 3.5 V.
•
All I/O pins of the ST72C171 are directly interconnected to the user application
board. No buffers or protective devices are inserted on the probe.
•
Probe mechanical dimensions: 123 mm x 100 mm (5"x 4").
•
SDIP32 or SO34 adapter height: 20 mm (0.8").
41/65