Download USER MANUAL
Transcript
Please refer to the following sheet for detailed information. Parameter Function RS232 COM You can use the COM or mini terminal to upgrade and debug the software. Function You can use special keyboard to control device via COM. Data Bit The value ranges from 5 to 8. Stop Bit There are three options: 1/1.5/2. Baud Bit You can select corresponding baud bit here. Parity There are four options: none/odd /mark/space. System default setup is: RS232: COM01 Baud rate: 115200 Data bit: 8 Stop bit: 1 Parity: None. Network Network interface is shown as below. Please refer to the following sheet for detailed information. Parameter Function Ethernet Please select the network card first. IP Address The IP address of this device, user can set the IP address according to his actual requirements. then set subnet mask, gateway correspondingly. DHCP Dynamically get IP address. You can get the device IP from the DHCP server if you enabled this function. Device Name Default name is NVD. You can input a new one if necessary. TCP Port Default value is 37777. HTTP Port Default value is 80. UDP Port Default value is 37778. Max Connection Network user max amount. The value ranges from 1 to 10. 21