Download PDF manual - Ocean Drilling Program

Moisture and Density (MAD) User’s Manual
18
4. Make sure the pycnometer and all the cells are empty and properly sealed because the program is about to start the blank run. Click OK to continue.
5. Click OK on the next message box to start the blank run.
6. Follow the directions in the displayed message box and click OK (See below).
7. To start the run with the sphere in cell #4 click OK.
8. Follow the directions in the displayed message box and click OK (See below).
9. If you would like a printout of the calibration factors, be sure the pycnometer is connected
to the printer and click Yes on the message box. If not click No.
10. Once the calibration is done, reset the pycnometer back to the main menu and click OK.
Ocean Drilling Program