1
Download User Manual - Seeed Studio
Transcript
WiFly GSX/EZX www.rovingnetworks.com WiFly-RN-UM 5/4/2011 10.6. Setting Debug Print levels There are a number of print functions that can be enabled to assist in debugging the operation and status of the module. The following command is used to control these printouts. set sys printlvl <value> sets additional print functions. Value is a bit-mapped register that controls which printout messages are sent to the UART. Print level 0 1 2 4 0x4000 0x10 Description Quiet mode. No messages printed when module wakes up or powers up. All status messages Only critical NETWORK AP connection level status is output, "Associated!" Or "Disconnect from <ssid>" DHCP and IP address status information Once the configuration has been checked; this can then be turned off so that these messages do not interfere with the data. New scan format output Enables uart heartbeat message. See section 10.6.2 for more details 809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • [email protected] ~ 43 ~
