Download AquaChem v.5.1 Demo Tutorial

Guidelines for you to gauge your data; you may also create and customize your own
water quality standards.
After reviewing the sample data, it was determined that the Calcium value was
incorrectly entered for this sample. You will now edit the data for the selected sample,
and enter the correct value for Calcium.
To edit the value for Calcium:
Cations from the list of available Parameter Groups
Locate Calcium (Ca) in the list of Parameters
Click once in the cell beside Ca, which has a current value of 125 mg/L
type: a new value of 120 mg/L,
press <Enter> key on your keyboard
At this point you would save the record by clicking the [Save] button at the bottom of
the Sample Details window, however, since this is a Demo version of the program this
feature is disabled.
Feel free to navigate through all of the samples in the Demo database using the
(previous and next) buttons in the lower left corner of this window.
and
Notice that when you open another Sample Details window, the window title is
updated to show the Sample ID of the newly selected sample. As well, the sample will
be highlighted in the Active List, allowing you to easily locate the sample and station
information simultaneously. (You may need to adjust the size and position of the
Sample Details window in order to see both windows on your display simultaneously).
Once you are finished reviewing the other samples,
[Close] to close the Sample Details window.
Next, you will take a quick glance at the Station Details.
Viewing Station Data
To view the station characteristics for one of the wells in the Demo database, you must
load the Station Details window.
To do so, first switch to stations mode:
Stations tab (at the top of the active list window)
MW-1 (Station ID), the first station in active stations list
Stations > Edit from the main menu (or you can press the <Enter> key
on your keyboard).
You should then see a Station Details window, similar to the figure shown below:
28
Chapter 2: Demonstration Exercise