Download Claire Lestrade - Parent Directory

Transcript
The material ‘Cu’ may then be chosen and the other parameters completed (x, y,
width, height) according to the calculation done above for the first conductor. This conductor
will then be displayed by clicking on ‘Plot’ towards the bottom of the conductor column. The
user may repeat those steps for each rectangular conductor (see Fig. 4.13). In case an error is
committed, it is possible to use the arrows to go back to the corresponding conductor. Once
the error is corrected, the user may press ‘Plot’ again.
4.3.4 Saving and solving the circuit
The user may follow the guidelines given in Section 4.1: the file is saved using the
option ‘File-Save’ from the menubar, the quality of simulation is chosen from the
‘Edit-Quality’ menu (50 for every conductor), and the mesh construction is started by
selecting ‘Mesh Construction’ from the file menu. Once this is done, four files have been
created: ‘ThreeRect,’ and the mesh files ‘Rect1.mesh,’ ‘Rect2.mesh,’ and ‘Rect3.mesh.’
These files do not need to be saved for future use.
The user may then simulate the structure by selecting the option ‘File-Solve’ on the
menubar and completing the potential simulation dialog. Four additional files have been
created in the process: ‘ThreeRect.in,’ ‘ThreeRect.out,’ ‘ThreeRect.Q2D,’ and
‘ThreeRect.V2D.’ The resulting matrices may be displayed by selecting the option ‘RLGC’
from the view menu. The L, G, and C matrices will be of dimension 3H3 because there were
three conductors considered in the structure. If this structure was to be viewed or modified
again in the future, only the file ‘ThreeRect,’ which contains the geometry of the interconnect,
is required. However, the files ‘ThreeRect.out’ and ‘ThreeRect.V2D,’ which contain the
RLGC matrices and the potential distribution, would be necessary in order to see the results of
the last simulation.
4.4 Four Conductors in a Layered Medium
4.4.1 Hypothesis and geometry considered
We consider the structure shown in Fig. 4.14. We assume that the four rectangular
conductors are identical and that the number of basis functions per side is 50 for each
conductor.
40