Download ProCAL - Ecotrons

ECOTRONS
ProCAL-manual-v2.8.3
BluetoothFinder_MFC began to search for a matching Bluetooth signal, once found, click on the
search for the Bluetooth signal, and then click Next to connect. If you are using the Ecotrons
Bluetooth module, the default name is Ecotronsxxx (xxx: serial number), the default password is
1234.
If you can not connect successfully, please try again.
Figure 3.2.2.8 Matching Bluetooth
3.3 Connect
Note1: Please confirm the ECU is powered on (The fuel pump will
make some noises when key-on!)
Note2: Please confirm you select the correct way of communication
mode (USB/COM/Bluetooth/Ethernet)!
3.3.1 Establish the communication
(If you have multiple CAL files in the project tree, the left window, you may want to highlight the
desired CAL file). Go to menu "Run connect", ProCAL will try to establish the communication
between the laptop and the ECU. If the A2L file you loaded in the ProCAL does not match the
software that is pre-loaded in the ECU, you will be prompted "Software mismatch!" And you
either need to load the correct A2L file into ProCAL, or you have to flash the ECU with the
matching software file (contact us for the correct ECU S19 file).
Figure 3.3.1.1
www.ecotrons.com
Page 15