Download Series 4000 Programmers Reference

Series 4000 SCPI Programmers Reference Manual
3.13.1 Output State
Syntax
OUTPut{[1]|2}[:STATe] {OFF|0|ON|1}
OUTPut{[1]|2}[:STATe]?
Description
The OUTPut{[1]|2}[:STATe] command switches the instrument's TEC output on/off.
Example
?
OUTP ON
Switches the TEC output of a TED4000 Series instrument on.
?
OUTP?
Queries the state of the TEC output of a TED4000 Series instrument.
?
OUTP2 ON
Switches the TEC output of an ITC4000 Series instrument on.
?
OUTP2?
Queries the state of the TEC output of an ITC4000 Series instrument.
?
1
The response is ASCII 1 if the output is switched on or an ASCII 0 if the output is off.
Note
The *RST
10
command switches the output off.
Note
These commands are valid for TED4000 and ITC4000 Series instruments only. For TED4000
Series instruments the command suffix is 1 (can be omitted), for ITC4000 Series instruments
the suffix is 2.
3.13.2 Protection Queries
Syntax
OUTPut[1]:PROTection:CABLe:TRIPped?
OUTPut[1]:PROTection:TRANsducer:TRIPped?
OUTPut[1]:PROTection:OTEMp:TRIPped?
Description
The OUTPut[1]:PROTection:CABLe:TRIPped? query command returns a 1 if the cable
connection from pin 1 to pin 15 (interlock) of the TEC-DRIVER 17W2 D-Sub jack is disrupted
and returns a 0 if the connection is closed.
The OUTPut[1]:PROTection:TRANsducer:TRIPped? query command returns 1 if a sensor
failure condition is detected and a 0 if a sensor is detected.
The OUTPut[1]:PROTection:OTEMp:TRIPped? query command returns 1 if the internal
temperature of the instrument is too hot and a 0 when not.
60
© 2012 Thorlabs