Download ID850QB Ver. 3.40 Integrated Debugger Operation UM

APPENDIX E MESSAGES
Ff805: Cannot set temporary break on this address.
Ff806: External data is being used by Debugger.
Ff900: Illegal I/O port name.
Ff901: Memory mapping error.
1) The specification of the address is illegal. Check the addresses that can be specified in the Add I/O
Port Dialog Box.
Ff902: Illegal access size.
Ff903: Illegal access type.
Ff904: There is the same name.
Wf905: [XXX] is already exist. Do you replace it?
Wf906: Would you like to register the change made in [XXX]?
Ffa00: The [XXX] function of current program on PC position not found.
1) The symbol specified in main() label: in the Debugger Option Dialog Box could be found. Set a
symbol of the main routine of the program. Default is _main.
Ffa01: The line information on PC position not found.
1) The source file corresponding to program counter (PC) value when the program was stopped could
not be found. The following reasons are possible.
-The source file exists in a location that the source path does not connect to.
-The program stopped where the source files, such as library or RX, do not exist.
-The program looped, jumped to an address that is not used by the program, and stopped there.
Wfb00: User program is running. Do you want to stop user program?
1) <Yes> button is selected, execution of the user program is stopped and then the Exit Debugger
Dialog Box is displayed. If it is specified in the Debugger Option Dialog Box that the Exit Debugger
dialog box is not to be displayed, however, the ID850QB is terminated.
<No> button is selected, execution of the user program is not stopped and the Exit Debugger Dialog
Box is not displayed. The ID850QB is not terminated.
Wfb01: Since bit 7 of address 0x79 in the ID code are 0, The N-Wire emulator becomes prohibition of use
henceforth. Do you exit the debugger as it is?
Ffc00:
Online help window cannot be started. Please install HTML Help environment with reference to a users
manual.
Wfc01: There is a bank of write mode in the instruction RAM. (IRAMM=0x??) Do you go on to execute?
Ffd00: Failed to specify [XXX].
Ffe00: The maximum size of RRM was exceeded.
Wfe01: There is a duplicate RRM address.
Wfe0b: It shift to the flash mode. Is it completely cleared but is the present event. Doesn't it care?
Ffe0c:
RAM monitor is enabled.
The present software break points are completely disabled. Doesn't it care?
Fffff:
390
Interrupted.
User’s Manual
U18604EJ1V0UM