Download Operator`s Guide Dimmer Rack

Transcript
Dimmer Events If the Module Event LED is on, the LCD will show the number of dimmer events
and will automatically scroll the display to show a description of the event(s).
Refer to the appendices section of this manual for a description of event codes. If
any other LED does not illuminate correctly, switch OFF the power immediately
and check the installation again. If the fault persists and all wiring seems correct,
call Strand Lighting or your local Authorized Service Center
(www.strandlighting.com).
After Startup 1. Check the following items to make sure they are correctly set in the processor
2.
3.
module:
• Module type (see Rack Config Menu in section 3, Front Panel
Programming)
• Rack name (see Rack Config Menu in section 3, Front Panel
Programming)
• Starting multiplex signal number and dimmer protocol (see Patching Menu
in section 3, Front Panel Programming)
• Time and date (see Rack Config Menu in section 3, Front Panel
Programming)
Other items you may wish to check at this time, depending on your system
configuration, are:
• Mux patch (see Patching Menu in section 3, Front Panel Programming)
• Outlook patch (see Patching Menu in section 3, Front Panel
Programming)
• Language (see Rack Config Menu in section 3, Front Panel
Programming)
• Max Voltage (see Rack Config Menu in section 3, Front Panel
Programming)
• Min Level (see Rack Config Menu in section 3, Front Panel Programming)
Switch on all load circuit breakers.
Connect a suitable luminaire to each outlet and check every dimmer using the
SET LEVEL control facility, a suitable control console, or an SWC hand held
controller. Investigate and correct any malfunctions you find.
If any dimmers do not work, stop and check the slot type for the dimmer.
Dimmers will not work properly if their slot type is incorrectly assigned.
Make sure that all of the modules are in their correct slots, and that the slot
type for each dimmer is correctly set in the processor module.
5.
Page 15
Install the fan screens, door, to complete the system installation.
C21/EC21 Series Dimmer Rack