Download 10500 Installation Guide

Step4
Remove the cable ties from the power cable, and remove the power cable from the power module.
Step5
Use a Philips screwdriver to loosen the captive screw on the power module, and then grasp the captive
screw between your thumb and index finger to carefully pull out the handle on the power module, as
shown in callout 1 on Figure 34.
Step6
Holding the power module handle with one hand and supporting the bottom of the power module with
the other, gently pull the power module out, as shown in callout 2 on Figure 34.
Step7
Put the removed power module on the antistatic mat.
Step8
Install a new power module. For the installation procedures, see the chapter “Installing modules.”
WARNING!
• To install the removed power module to the chassis again, install it after the status LED on it is off.
• The power module may be of high temperature. Remove it with caution.
Figure 34 Remove the power module
1: Loosen the captive screw
2: Pull the power module out
CAUTION:
After removing the power module, if you do not install a new power module, install a blank panel.
51