Download - Rorke Data

Transcript
Chapter 2 Hardware Installation
Chapter 2
Hardware Installation
2.1. Installation Overview
This chapter gives detailed instructions on how to install the Galaxy A24F
subsystem. When installing the subsystem, it is necessary to install hard drives, drive
trays, and cables. Installation into a rack or cabinet should occur before the hard
drives or drive trays are installed into the subsystem. It is also advisable to confirm
that all of the components listed on the printed Unpacking List that came with the
subsystem were indeed included.
CAUTION!
For purposes of maintaining, viewing, and instructing the proper procedure for
installing components in the Galaxy, the installation of components are included in
this manual. Please note that the installation instructions described in this manual
should be carefully followed in order to avoid damage to the subsystem.
2.2. Installation Pre-requisites
1.
Static-free installation environment: The subsystem must be installed in a
static-free environment to minimize the possibility of electrostatic discharge
(ESD) damage. (See Section 2.3)
2.
Component check: Before installing the subsystem, you should confirm that you
have received all of the required components by checking the package contents
against the Unpacking List.
3.
Memory modules: If you wish to change the pre-installed memory modules, the
separately purchased modules must be installed. (See Section 2.6.2)
4.
Hard drives: SATA hard drives have been integrated based on the size of drives
you have purchased. Replacement drives may be installed. (See Section 2.7)
5.
Cabling: All optical FC cables and SFP transceivers are user-supplied. Contact
Rorke sales to purchase these components. (See Section 4.2.1)
6.
Rack installation: The enclosure chassis can be installed into standard, 19-inch
wide rack cabinet using self-purchased mounting rails or Galaxy slide rails.
Installation Overview
2-1