Download FUSION SPLICER

Transcript
BASIC OPERATION
This chapter outlines step-by-step everything you need to
know to make clean, low-loss splices using the EC1. Since
every splicer is slightly different, it is recommended that you
read through this chapter before you set to work, regardless of
your previous level of experience. Once you are familiar with
the splicer’s basic operation, you can learn how to personalize
EC1’s capabilities to suit your particular needs by looking in
the chapter entitled “Advanced Functions.”
1. Set-up
Page 6
Particularly the first time, it is advisable to follow through stepby-step how to get the EC1 from its carrying case and into
use.
2. Program selection
Page 7
The right splice requires the right splicing program.
3. Fiber preparation
Page 8
Possibly the most important element of good splicing is correct preparation of the fibers. Carefully follow the guidelines
listed on these pages concerning stripping lengths, end face
quality and cleanliness.
4. Splicing
Page 10
As the EC1 is an entirely manual splicer it is necessary to
carefully position the fibers before splicing and afterwards to
check for bulges and waists.
5. Splice protection
Page 13
Assuming all goes well, one can wrap up the splicing process
by protecting the splice with a heat-shrink sleeve.
BASIC OPERATION
5