Download Ajna Light 2

Transcript
20.
Choose the intensity of the light by moving the slider forwards and backwards to
increase/decrease the brightness. For your first time it is recommended that you use 30%-50%. If
you spend a lot of time on a computer, have eye strain, had previous eye surgery, experience
migraines or are sensitive to light then start off with a light intensity of 5% -10%. Asian &
Indigenous people are usually light sensitive, so start them of with 5%.
If you need to adjust the light intensity during a session, press/touch the play/pause button, move
the tab on the light intensity slider up or down, then press the play/pause button again. The light
and music keep playing during this time, the timers stop until you press the play button again.
21. Make sure there is good airflow in the room or use an external fan directed towards the
back of the lamp.
22. You are now ready for your session. Sit or lay down with the Ajna Lamp LED's directed at your
forehead, approximately 30 – 50cm away.
23.
Adjust your headphones so they are comfortable, press play, close your eyes and
enjoy your session.
The light/s will start flashing approximately 4 seconds after the play button has been pressed and
finish up to 4 seconds after it has finished.
The music is synchronized to start when the light/s start flashing and the music stops when the
light session stops regardless if the song is finished or not.
The Ajna Lamp is a computer and must be shut down correctly.
To do this press/touch the red square on the top right side of the screen and then a
yellow shutdown box will appear....
timer will start.
Press/touch this box and the countdown
Once it reaches 0/zero, the following will
appear…
Now you can disconnect the power supply.
- 17 -
Back to index