Download SOLARDRIVE PLUS

SOLARDRIVE
PLUS
6.5.
6.5.1.
INSTALLATION AND
PROGRAMMING GUIDE
Measures Menu
Overview
The Measures Menu contains the variables measured by the drive that can be used by the user.
In the display/keypad, measures are divided into subgroups.
This manual covers the measurements for the solar pumping application. For information on other available
measurements, please contact Elettronica Santerno S.p.A.
The measure subgroups are the following:
Motor Measures Menu
This menu contains: the values of the speed reference at constant rpm, the values of the reference being
used and the speed values of the connected motor expressed in rpm; the drive rated frequency and the
electrical variables measured by the drive mains side, the DC-bus and output.
PID Controller Menu
This menu contains the values relating to the PID controller of the drive.
Digital Inputs Menu
This menu contains the state of the drive digital inputs and the indication of the functions programmed for the
digital inputs of the drive.
References Menu
This menu contains the following values: analog references, the encoder input and the frequency input
references, the speed/torque or reference/feedback values of the PID coming from serial link or fieldbus.
Outputs Menu
This menu contains the state of the drive digital outputs, analog outputs and frequency outputs.
Autodiagnostics Menu
This menu contains the temperature values, the operation time counter and the supply time counter, the
active alarm and the drive status.
Digital Input Settings Menu
This menu contains the functions assigned to the digital inputs.
Fault List Menu
This menu contains the trip log of the last eight alarms tripped and the values of some measures being used
when the alarm trip was stored.
PowerOff Log Menu
This menu contains the value of some measures being used at the drive power off.
88/160