Download Falcon IV - RAID Inc

Transcript
Chapter 1: Introduction
hours, there may be a problem with the BBU mod ule. You may reinstall the b attery; and if the battery still sho
ws probl ems with
charging, co ntact your system vend or for a re placement. While t he
battery is being charged, a system event will prompt.
You can ch eck battery’ s charge level using a termin al con sole wi th
firmware’s embedded utility.
1.2.7
Power Supply Units
PN: IFT-9274CPSU
The sy stem is eq uipped with thre e (3 ) re dundant, hot-swa ppable,
load-sharing 405W PSUs, at the rear se ction of the cha ssis. T he
PSU is housed in a 1U canister containing both the power supply and
dedicated cooling modules.
A single LED indicate s the PSU status. When a power sup ply failure
occurs, the L ED lights red. An extr action han dle at the rea r of the
PSU is designed to help properly install or remove the module.
A scre w hol e on the extra ction h andle helps secure the PSU to t he
chassis. The shipping package contains adjustable cable clamps that
can be used to secure power cord connections.
Figure 1-11: PSU Module
Please refer to
PSUs.
1.2.8
Appendix A for the technical information of
the
Cooling Modules
PN: IFT-9374CFANMOD
Two cooling modules at t he re ar center ventilate t he sy stem. (see
Figure 1-12.) The cooling fans ope rate at two (2) fan speeds. When
the system operates normally, the cooling fans operate at the lo wer
speed. If a system mod ule fails or when one of the tempera ture
System Components
1-11