Download fastrack ii helmet manual

1. To answer a call:
2. To terminate a call:
6. To transfer the sound back to your mobile phone: During a call using your headset, press the
Multi-Function Button (MFB) for approximately 2 Seconds. If your headset works with Head Set Profile,you just
need turn off your headset.
Note: If the Multi-Function Button (MFB) is pressed too long, the call will end.
3. To reject a call: When the headset rings, press and hold the Multi-Function Button (MFB) on the helmet
control for about 3 seconds and release the MFB to reject an incoming call. Note: this function is valid only if
your phone supports Hands-Free Profile.
7. To transfer sound from mobile phone to BLINC headset:
4. Last Number Redial: When the headset is idle, double click the Multi-Function Button (MFB) to redial the last
called phone number.
8. Taking a phone call while in intercom mode:
helmet. When the call arrives,the intercom will disconnect autmatically, then you can press the Multi-function
(MFB) to answer the phone call.
Note: Not all phone brands may apply,if you can not hear the incoming call, you need set your mobile phone on
the vibrate mode and position it so that you will feel it vibrate. When the call arrives, press the Multi-Function
(MFB) on the helmet control unit once to end the intercom connection, they press it again to answer the phone
call.
5. To use Voice Commands:
Since both Driver and Passenger are in pairing mode, intercom connection will be
established between them automatically,and both side will hear 3 pulsing ringtones in speaker. Once you are
connected, you will be able to communicate without needing to touch the button again. If the helmets get out of
range (about 30 feet), you may lose the connection.As soon as the helmets are back in range, they will automatically
be reconnected and voice communication will be restored.
First, be sure the headset is switched off.Then on the GPS enter the“Add Bluetooth device mode”.Once your GPS is
searching for Bluetooth® device, please press and hold the Multi-Function Button (MFB) on the helmet control unit
for approximately 6 seconds until the blue LED and red LED are flashing alternatively.
Second, select “helmet_intercom_over” from Bluetooth device list on your GPS and input password/PIN “0000” at
your GPS.
When BLINC™ headset is connected with GPS, you can hear the navigation prompts.
NOTE: When BLINC™ headset is connected with GPS, it can not be connected with your phone or other devices .If
you want to answer the dial, first you can let your phone be connected with GPS, then let GPS be connected with
BLINC™ headset, more information for this, you can refer to your GPS user manual.