Download Manual - Sit Automation

Table of Content
01
02
03
04
05
06
07
08
09
10
11
12
13
14
Introduction .......................................................................................................................1-1
Installation .........................................................................................................................2-7
Wiring ……………………………………………………………………………………...……3-11
Main Circuit Terminal.......................................................................................................4-13
Control Terminal…………………………………………………………………………….…5-17
Optional Accessories.......................................................................................................6-21
Option Cards ...................................................................................................................7-41
Specifications ..................................................................................................................8-57
Digital Keypad .................................................................................................................9-59
Summary of Parameter Settings ...................................................................................10-63
Description of Parameter Settings.................................................................................11-73
Warning Codes..............................................................................................................12-99
Fault Codes and Descriptions .....................................................................................13-103
CANOpen Slave ........................................................................................................14-109
PLEASE READ THE FOLLOWING INFORMATION PRIOR TO INSTALLATION FOR SAFETY.
 AC input power must be disconnected before any wiring or connection is made to the
AFE2000.
 A charge may still remain in the DC-link capacitors with hazardous voltages after the power
DANGER





CAU TION

has been turned off. DO NOT touch the internal circuit and any other components before the
Power LED indicator is off.
There are highly sensitive MOS components on AFE2000 printed circuit boards. These
components are especially sensitive to static electricity. Please do not touch these
components or the circuit boards before taking anti-static measures. Never reassemble the
internal components or wires.
Ground AFE2000 using the ground terminal. The grounding method must comply with the
laws of the country.
Keep AFE2000 and the installation away from fire and inflammables.
Only the qualified personnel are allowed to install, wiring, and repair the drive.
A hazardous voltage may still remain in the AFE2000 main circuit terminals even when the
three-phase DC motor is at stop status.
If AFE2000 is not charged for more than 3 months, keep the ambient temperature lower than
30 °C. It should be avoided keeping AFE2000 in storage for over a year; it could cause
degradation of electrolytic capacitors.
NOTE

The content of this manual may be revised without prior notice. Please consult our distributors or download the recent
version at ( http://www.delta.com.tw/industrialautomation/ )
I