Download Intelligent bark

User’s Manual
Parts & Function
Spray Nozzle
Bark Control Collar
Battery Door
Refill Port
Power Button
User’s manual
Battery
Refill Canister
Refill Light
Power Light
Install Battery: Open the battery door. Take care to install the battery properly.
Align the “+” on the battery to the “+” of the battery holder. After inserting the
battery always check that the battery door is closed fully.
Switch ON: Push and hold the power button switch down for at least two seconds
until you see the green indicator light flash once. The collar is now switched ON.
Notice the green indicator light flashes briefly about every five seconds to indicate
it is currently switched ON.
Switch OFF: Push and hold the power button down for at least two seconds until
you see the green indicator light quickly flash several times. The collar is now
switched OFF. Once switched OFF the green indicator light will not flash. If you do
not intend to use the collar for a few days remove the battery to improve its life.
Fill the Collar with Spray: Hold the spray can upright and firmly press the nozzle
down into the refill port. Hold for 15 seconds. If spray leaks out press harder to
complete the seal.
15
Seconds
Refill the Collar: The yellow indicator light will flash when the collar needs refilling,
but you may prefer to top up the collar at the start of each day to ensure it is
always full. When refilling: 1/ Remove the collar from off the dog. 2/ Switch the
collar OFF. This is important to reset the spray counter to indicate the reservoir is
now full. 3/ Make sure the filling port is clean of dust or dirt before filling or
damage may result. 4/ Fill as described above. 5/ Switch the collar ON. 6/ Place
the collar back on the dog. IMPORTANT: Do not allow the collar to run out of spray
as this may lessen the effectiveness of the training.
CAUTION: the refill can is a pressurized container. Keep the can away from direct
sunlight or other sources of heat. Do not expose it to temperatures exceeding
45oC. Do not expose to freezing temperatures below 0oC. Do not pierce or burn the
can after use. Use only as directed.
Adjust Spray Amount: Provision has been made to adjust the amount of spray
emitted by the collar. We recommend you use the factory setting as shown in the
image. If any adjustment is made it must not be more than 1/8th of a turn either
clockwise or anticlockwise from that shown in the diagram.