Download 2330 Controller User Manual

2330 Controller
www.snellgroup.com
Controller Card Configuration
4. Controller Card Configuration
4.1 Jumper Information
A number of jumpers on the 2330 controller card can be positioned to give different
configurations. Do not change the jumpers when the card is in operation.
PL13
PL53
WDOG
PL9
PL11
PL12
PL10
PL49
Fig 14. Jumper Positions
4.1.1 PL9
NTSC/PAL selection for composite video output. (NOT IMPLEMENTED)
Jumper on pins 1 & 2
PAL (DEFAULT)
Jumper on pins 2 & 3
NTSC
4.1.2 PL10 & PL12
Terminate the RS422 RX and TX lines for Port RTCOM1. DEFAULT = FITTED
Must be removed if Port RTCOM1 is used as an RS232 port.
4.1.3 PL11 & PL13
Terminate the RS422 RX and TX lines for Port RTCOM2. DEFAULT = FITTED
Must be removed if Port RTCOM2 is used as an RS232 port.
4.1.4 PL49
Forces the card active for development and testing and should not be fitted for normal
operation. DEFAULT = NOT FITTED
4.1.5 PL53
TC/VGA selection for Timecode or Composite video for composite video output. (NOT
IMPLEMENTED)
Jumper on pins 1 & 2
VGA (DEFAULT)
Jumper on pins 2 & 3
Timecode (Automation only)
4.1.6 WDOG
Software Watchdog
Issue 1 Rev 1
Jumper on pins PC
Normal operation (DEFAULT)
Jumper on pins CLK
Disabled for software testing
Page 17
© 2012 Snell Limited