1
Download Sun Fire Midrange System Controller Command Reference Manual
Transcript
TABLE 3-5 Results of Changing the Keyswitch From the Current Setting to a New Setting (Continued) Current Setting New Setting Result standby on Similar to setting the virtual keyswitch from off to on except that you do not have to wait for the system controller to turn on the boards and prepare them. standby standby Keyswitch position not changed. standby diag Similar to on, except POST verbose and diagnostic level is to set to maximum. The domain will boot from the diag-device. standby secure Similar to on, except the reset and break commands are ignored by the domain shell. on off All boards will be powered off (set to low-power mode and all monitoring of the boards will stop). The domain is shut down. on standby The domain becomes inactive. All of the boards remain powered on. on on Keyswitch position not changed. on diag Similar to the setkeyswitch on command except the POST verbose mode is set to on and the POST diagnostic level is set to maximum. This change is setting has no effect on a running domain. on secure break and reset are ignored. diag off All boards will be powered off (set to low-power mode and all monitoring of the boards will stop). The domain is shut down. diag standby The domain becomes inactive. All of the boards remain powered on. diag on Has no effect on a running domain. This operation only changes the keyswitch position and does not perform any other function since the domain is already running. diag diag Keyswitch position not changed. diag secure break and reset are ignored. secure off All boards will be powered off (set to low-power mode and all monitoring of the boards will stop). The domain is shut down. secure standby The domain becomes inactive. All of the boards remain powered on. The break and reset commands are no longer ignored. secure on break and reset are not ignored. secure diag This change is setting has no effect on a running domain. secure secure Keyswitch position not changed. Chapter 3 System Controller Alphabetical Command Reference 79
