Download MiCOM P594
Transcript
P594/EN OP/E33 Operation (OP) 4-8 MiCOM P594 The setting [CONFIGURATION, GPS Position] determines the behavior of the P594 following reload of the default settings - when [CONFIGURATION, Restore Defaults] is set or following a software update. If [CONFIGURATION, GPS Position] is set to ‘Auto Survey’, then following reload of default settings or a software update, an auto survey is performed after it detects four or more satellites. This will take approximately 10 minutes before it starts to output the 1PPS signals. If [CONFIGURATION, GPS Position] is set to ‘Stored Check’, then following reload of default settings or a software update and after it detects four or more satellites, 120 position fixes will be received and then the next positional information data received will be compared to the information stored in memory. If the co-ordinates (Longitude and Latitude only) are within ±0.001° of each other, then the co-ordinates stored in memory will be used and the P594 starts to output the 1PPS signals. If the co-ordinates are not correct then the ‘WRONG POSITION’ LED will be illuminated and an auto survey will be initialised. This will take approximately 2 minutes. If [CONFIGURATION, GPS Position] is set to ‘Stored No Check’, then following reload of default settings or a software update and after it detects four or more satellites, the co-ordinates stored in memory will be used and the P594 starts to output the 1PPS signals. This will take approximately 10 seconds. OP CAUTION: IF THE P594 UNIT HAS BEEN MOVED TO A NEW LOCATION, AN AUTO SURVEY MUST BE COMPLETED BEFORE THE CO-ORDINATES STORED IN MEMORY WILL BE CORRECT. Once initialized, and provided the unit detects four or more satellites and the almanac is loaded, the ‘SYNC’ LED is illuminated. If the number of satellites drops below four the output turns off and the ‘SYNC’ LED will extinguish, until the number of satellites detected exceeds four again. 1.6 Default display The default display of the LCD on the P594 front panel User Interface will look similar to the example shown in Figure 6 below: P 5 9 4 D 0 5 : 1 2 : 3 2 T Z + 1 : 0 0 # S AT = 1 2 Figure 6: Default display The text “P594” identifies the unit. The letter “D” will be displayed when Daylight Saving Time is applied. The text “05:12:32” in this example displays the time received from GPS. The text “TZ+ 1:00” in this example displays the local time zone offset. The text “#SAT=12” in this example displays the number of satellites currently detected (maximum 12). 1.7 LED indications The P594 has 8 LEDs on the front User Interface, to provide operational indications and alarms. 1.7.1 ‘P594 HEALTHY’ LED (green) This LED is illuminated when the P594 is energized from the auxiliary supply and is functioning correctly.