Download MiCOM P594

Transcript
P594/EN OP/E33
Operation
(OP) 4-8
MiCOM P594
The setting [CONFIGURATION, GPS Position] determines the behavior of the P594
following reload of the default settings - when [CONFIGURATION, Restore Defaults] is set or following a software update.
If [CONFIGURATION, GPS Position] is set to ‘Auto Survey’, then following reload of default
settings or a software update, an auto survey is performed after it detects four or more
satellites. This will take approximately 10 minutes before it starts to output the 1PPS signals.
If [CONFIGURATION, GPS Position] is set to ‘Stored Check’, then following reload of default
settings or a software update and after it detects four or more satellites, 120 position fixes
will be received and then the next positional information data received will be compared to
the information stored in memory. If the co-ordinates (Longitude and Latitude only) are
within ±0.001° of each other, then the co-ordinates stored in memory will be used and the
P594 starts to output the 1PPS signals. If the co-ordinates are not correct then the ‘WRONG
POSITION’ LED will be illuminated and an auto survey will be initialised. This will take
approximately 2 minutes.
If [CONFIGURATION, GPS Position] is set to ‘Stored No Check’, then following reload of
default settings or a software update and after it detects four or more satellites, the
co-ordinates stored in memory will be used and the P594 starts to output the 1PPS signals.
This will take approximately 10 seconds.
OP
CAUTION:
IF THE P594 UNIT HAS BEEN MOVED TO A NEW LOCATION, AN AUTO
SURVEY MUST BE COMPLETED BEFORE THE CO-ORDINATES
STORED IN MEMORY WILL BE CORRECT.
Once initialized, and provided the unit detects four or more satellites and the almanac is
loaded, the ‘SYNC’ LED is illuminated. If the number of satellites drops below four the
output turns off and the ‘SYNC’ LED will extinguish, until the number of satellites detected
exceeds four again.
1.6
Default display
The default display of the LCD on the P594 front panel User Interface will look similar to the
example shown in Figure 6 below:
P 5 9 4
D
0 5 : 1 2 : 3 2
T Z +
1 : 0 0
# S AT = 1 2
Figure 6:
Default display
The text “P594” identifies the unit.
The letter “D” will be displayed when Daylight Saving Time is applied.
The text “05:12:32” in this example displays the time received from GPS.
The text “TZ+ 1:00” in this example displays the local time zone offset.
The text “#SAT=12” in this example displays the number of satellites currently detected
(maximum 12).
1.7
LED indications
The P594 has 8 LEDs on the front User Interface, to provide operational indications and
alarms.
1.7.1
‘P594 HEALTHY’ LED (green)
This LED is illuminated when the P594 is energized from the auxiliary supply and is
functioning correctly.