Download Pro Sweep 5200

Jacking Instructions
CAUTION
1
When changing tires or performing other service, use correct blocks, hoists and jacks to
support sweeper. Make sure machine is parked
on a solid level surface such as a concrete floor.
Always chock or block wheels. Use jack stands
or solid wood blocks to support the raised machine. If the machine is not properly supported
by blocks or jack stands, the machine may
move or fall, which may result in personal injury.
1. Position sweeper on a level surface with dump hopper empty and lowered. Have sweeper attached to towing vehicle, engage vehicle parking brake, stop engine
and remove key from the ignition switch. Chock sweeper wheels to prevent it from moving.
2
Figure 1
1. Wheel
2. Frame jacking point
2. Position jack securely under the main sweeper
frame (Fig. 1). Do not use the axle as a jacking point.
3. Carefully jack machine off the ground.
4. Position jack stands or hardwood blocks under the
main frame to support the sweeper.
Safety
Page 1 – 4
Pro Sweep 5200