Download Pro Sweep 5200

1. Before servicing or making adjustments, empty
sweeper hopper and position sweeper on a level surface. Chock sweeper wheels to prevent it from moving.
If sweeper is attached to tow vehicle, engage tow vehicle parking brake, stop engine and remove key from
the ignition switch.
7. If hopper is raised, install lift cylinder stop to ensure
that unexpected shifting of sweeper frame does not occur.
2. Make sure machine is in safe operating condition by
keeping all nuts, bolts and screws tight.
9. If major repairs are ever needed or assistance is desired, contact an Authorized Toro Distributor.
3. Make sure all hydraulic line connectors are tight and
all hydraulic hoses and lines are in good condition before applying pressure to the hydraulic system.
10.At the time of manufacture, the machine conformed
to all applicable safety standards. To assure optimum
performance and continued safety certification of the
machine, use genuine Toro replacement parts and accessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with the safety standards, and the warranty may be
voided.
4. Keep body and hands away from pin hole leaks in hydraulic lines that eject high pressure hydraulic fluid. Use
cardboard or paper to find hydraulic leaks. Hydraulic
fluid escaping under pressure can penetrate skin and
cause injury. Hydraulic fluid accidentally injected into
the skin must be surgically removed within a few hours
by a doctor familiar with this form of injury or gangrene
may result.
5. Before disconnecting any hydraulic component or
performing any work on the hydraulic system, all pressure in system must be relieved. See Relieving Hydraulic System Pressure in the General Information section
of Chapter 3 – Hydraulic System.
6. If hopper is to be raised, make sure that sweeper is
not placed in the offset position.
Pro Sweep 5200
8. Disconnect electrical power harness from tow vehicle before servicing the sweeper.
11. When changing tires or performing other service,
use correct blocks, hoists and jacks. Make sure machine is parked on a solid level floor such as a concrete
floor with the hopper empty and lowered. Have sweeper
attached to towing vehicle, engage vehicle parking
brake, stop engine and remove key from the ignition
switch. Always chock or block wheels. Use jack stands
or solid wood blocks to support the raised machine. If
the machine is not properly supported by blocks or jack
stands, the machine may move or fall, which may result
in personal injury (see Jacking Instructions).
Page 1 – 3
Safety
Safety
Maintenance and Service