Download BM 100 A Reflex
Transcript
Function (Fct.) 1.3.0 CUR. OUTP. I Input Range 1.3.1 FUNCTION.I.1 Select Off, Level, Distance, Volume, Interface Level*, Layer*, Interface Distance*, Interface Volume* or Ullage Volume. Level 1.3.2 RANGE.I 1 1.3.3 SCAL.I.1 MIN (Scale I1 Minimum) 1.3.4 SCAL.I.1 MAX (Scale I1 Maximum) Select 4-20 mA, 4-20 mA with a 3.7 mA failsafe output or 4-20mA with a 22mA failsafe output. 4-20 mA, E=22mA Enter value with regards to measure method selected in Fct.1.3.1 and the units set in Fct. 1.2.5. As per order or 0.0 Enter value as in 1.3.3 Description This configures the current output. These functions are independent from what is displayed. Assigns a measurement parameter to analogue output number 1. * These parameters are not displayed in this sub-menu unless the instrument is configured for interface measurement. Calibrate the gauge using Function 1.7.2 Strapping Table before selecting “Volume” here. Sets the analogue output range. Settings with fail-safes will send an error message if an error occurs i.e. the level is lost. Assigns a length or volume value to 4 mA. Refer to section 3.4.3, Example Procedure 4. Assigns a length or volume value to 20 mA. Refer to section 3.4.3, Example Tank height or probe length as given in order Procedure 4. 1.3.5 FUNCTION.I.2* Select as in 1.3.1 Same as Fct. 1.3.1, except this is for the second current output, if ordered. Level 1.3.6 RANGE.I 2* Select as in 1.3.2 Same as Fct. 1.3.2, except this is for the second current output, if ordered. 4-20 mA 1.3.7 SCAL.I.2 MIN* Enter value as in 1.3.3 Same as Fct. 1.3.3, except this is for the second current output, if ordered. As per order or 0.0 1.3.8 SCAL.I.2 MAX* Enter value as in 1.3.4 As per order or Tank Height Same As order or Tank Height as Fct. 1.3.4, except this is for the second current output, if ordered. *Displayed when interface measurement is selected in the factory menu Handbook BM 100 A 35