Download SERVICE MANUAL - e-ASP

Chapter 2
Disassembly Process
2-1 Equipment Needed & Product Overview
1. Screw Bit (+) :105
2. Screw Bit (+) :107
3. Screw Bit (-) :107
4. Hex Sleeves 5 mm
5. Tweezers
6. Projection
* Before you start: This process is protective level II. Operators should wear electrostatic chains.
* Note: If you need to replace the main board, you have to get into service mode and record the
lamp usage hour.
As the disassembly process of EW330/EX330/EW330(1W)/EX330(1W) is the same, we
take EX330 for example here.
EX330/EW330/EW330(1W)/EX330(1W)
Confidential
2-