Download Triple Depth Vender with 4-button programming

SECTION 2: SET-UP AND INSTALLATION
Setting the Adjustable Product Retainers
NOTE: Since new packages are constantly being introduced, the listing in Figure 2.2 may not contain ALL vendible
packages. For the latest information on packages that will vend in the 20 PLUS, please contact Royal Vendors’
Customer Service department (800) 931-9214.
Front Retainers - Columns 1 through 6
(Figure 2.3)
Rear Retainers - Columns 7 through 12
1.
1.
2.
3.
4.
Determine Correct Position for Package Type
(See Figure 2.2).
Use Figure 2.2 to determine the proper position for the
package type to be vended.
Determine if Retainer is Already in Proper Position.
Check the current position of the front retainer. Note
that slots are counted from front to rear of the vender;
i.e. retainer position 3 would be the third slot from the
front of the machine. “Counting holes” located
beneath every third slot will aid in positioning. If
retainer is already in the correct position, go to Step 4.
Reposition Front Retainer (If Necessary).
Lift the front retainer upwards, pivoting the upper
portion out and away from the column wall. This will
allow the front retainer to be lifted further in order to
disengage the lower hook. Re-install the retainer,
reversing the removal procedure. Make sure hooks
are in aligned slots at both the top and bottom.
Repeat for Column’s Other Front Retainer.
Adjust the column’s other retainer, making sure it is
located in the same number slot.
2.
3.
4.
Determine Correct Position for Package Type
(See Figure 2.2).
Check Figure 2.2 for the correct retainer position.
Determine if Retainer is Already in Proper Position.
Check the current position of the rear retainer. Note
that slots are counted from the front to the rear of the
vender. If retainer is already in the correct position,
skip Step 3.
Reposition Rear Retainer.
Pull out at the bottom of the retainer and this will
unsnap it from its slot. Then lift up on the retainer to
disengage the top hook. Reinstall the retainer by
hanging the top hook in the desired slot and
snapping the bottom of the retainer into the aligning
slot.
Repeat for Column’s Other Front Retainer.
Adjust the column’s other retainer, making sure it is
located in the same number slot.
Figure 1
Package Orientation
See Fig. 2
Figure 2
Figure 4
See Fig. 4
Rear Retainer
Front Retainer
See Fig. 5
Figure 3
Page 12
Figure 5
See Fig. 3
20 Plus Vender