Download Operators Manual - Snap

Chapter I Introduction
!! IMPORTANT NOTE !!
Shutting Down the Computer
To avoid damaging important files It is
necessary to shut down Windows® properly
before turning off or restarting the aligner
or the computer.
Use the following steps to shut down the aligner
from within the Alignment software:
1. Return to the Home Alignment screen.
2. Power off the PC using Software control,
the “SHUT DOWN WINDOWS®” icon at
the lower right corner of the Home Screen
followed by turning the switch off at the
rear of the aligner.
Note: The switch must remain off a
minimum of 10 seconds before it can
be turned back on.
From the Windows® desktop:
1. Close any programs or applications that
may have been opened.
2. Click the Start button, and then click Shut
Down.
3. On the Shut Down Windows® box that appears, select “Shut down the computer?”
Click “Yes” to proceed.
4. The computer will automatically shutdown. After the computer finishes shutting
down, turn the switch off at the rear of the
aligner.
Note: The switch must remain off a
minimum of 10 seconds before it can
be turned back on.
Page 1-10