Download 42re automatic transmission

21 - 222
45RFE AUTOMATIC TRANSMISSION
WJ
REMOVAL AND INSTALLATION (Continued)
(7) Install the shift cable to the shifter assembly
bracket. Push cable into the bracket until secure.
(8) Place the floor shifter lever in park position.
(9) Loosen the adjustment screw on the shift cable.
(10) Snap the shift cable onto the shift lever pin.
(11) Verify that the shift lever is in the PARK position.
(12) Tighten the adjustment screw to 7 N·m (65 in.
lbs.).
(13) Verify correct shifter operation.
(14) Install shift lever bezel and any console parts
removed for access to shift lever assembly and shift
cables.
BRAKE TRANSMISSION SHIFT INTERLOCK
Fig. 59 Transfer Case Shift Cable
1
2
3
4
–
–
–
–
CLIP
SHIFTER
TRANSFER CASE SHIFT LEVER PIN
TRANSFER CASE SHIFT CABLE
REMOVAL
(1) Lower the steering column.
(2) Remove the transmission shift interlock cable
from steering column (Fig. 61).
(3) Remove the center console and related trim.
Refer to Group 23, Body, for proper procedures.
(4) Disconnect the BTSI cable from the shift BTSI
lever and remove the cable from the shifter assembly
bracket.
(5) Disengage the wire connector at the solenoid
on the cable
(6) Release the BTSI cable from any remaining
clips.
(7) Remove BTSI cable from the vehicle.
INSTALLATION
NOTE: The gearshift cable must be secured into
position and properly adjusted before the installation of the Brake Transmission Interlock Cable
(BTSI).
Fig. 60 Shifter Assembly
1 – FLOOR PLAN
2 – SHIFTER ASSEMBLY
(2) Install the nuts to hold the shifter assembly
onto the floor pan. Tighten nuts to 28 N·m (250 in.
lbs.).
(3) Install wiring harness to the shifter assembly
bracket. Engage any wire connectors removed from
the shifter assembly.
(4) Install the transfer case shift cable to the
shifter assembly bracket. Install clip to hold cable to
the bracket.
(5) Snap the transfer case shift cable onto the
transfer case shift lever pin.
(6) Install the brake transmission interlock cable
into the shifter assembly bracket and into the shifter
BTSI lever.
(1) Snap the BTSI cable assembly into the steering
column.
(2) Snap BTSI cable solenoid tie strap into hole in
steering column tube.
(3) Engage the wiring connector from brake light
switch into BTSI cable solenoid housing.
(4) Route BTSI cable to the shifter mechanism.
(5) Install the BTSI cable end fitting into shifter
BTSI lever.
(6) Pull rearward on the BTSI cable housing and
install the cable housing into the shifter assembly
bracket.
(7) Place the ignition key cylinder in the LOCK
position.
(8) Snap BTSI cable adjuster ears into floor shifter
bracket and
(9) Push the cable adjuster lock clamp downward
to lock it.