Download EtherCAT Slave Controller (EH-IOCA

Chapter 4
4.1
Installation
Mounting modules
(1) Mounting
1] Hook the lower part of the module to the hole in
②
the base.
2] Press in the upper side of the module until it clicks.
Note 1: Make sure the module is mounted securely.
①
Note 2: Slot position of power supply module is
fixed as 1st slot of base unit.
Note 3: Slot position of CPU module is fixed as 2nd
slot of base unit.
Modules can be fixed firmly by M4×10mm screws.
Figure 4.1-1 Mounting Module
(2) Removing
①
③
1] Press the lock button.
2] With the lock button pressed, pull the top of
the module.
②
3] Pull the unit away from the base unit.
Note: Press the lock button for a power supply
module.
Figure 4.1-2 Removing Module
4–1