Download reytec - TOMEI

Wire Preparation
1.Connector Preparation
(For Air-temperature sensor)
① Put an insulation sleeve thru a wire.
② Remove about 5mm of vinyl tunic of the
wire and place the wire on a connector. Pinch
the smaller nails with connector pliers.
③ Paste solder to the part shown in ② and
pinch remaining nails.
④ Put the insulator in place.
2. Terminal Preparation
(For Boost pressure sensor)
① Put a rubber-bushing thru a wire.
② Remove about 3mm of vinyl tunic of the
wire and place it on a terminal. Pinch the
smaller nails with connector pliers.
③ Paste solder to the part shown in ②.
④ Put the insulator in place and pinch
remaining nails.
５