Download here - Agilent Technologies

For this exercise:
l use a 5 MHz square wave connected to channel 1, and set the
sweep speed to 50 nsldiv.
. Set the Display mode to Real Time and notice that the memory
bar is displayed.
After the signal is displayed:
l select the delay function of the Timebase
menu and use the
entry devices to vary the delay.
- while running (STOP/SINGLE key not pressed), varying
DELAY will vary the acquisition record with respect to the
trigger point.
DELAY
Delo
R e f ar
center
J
Trg’ d
Sweep
Figure 7.3 Memory Bar Using Delay.
Display Menu
7-4