Download Fuel System - Hansen Web Design
Transcript
Donated by John & Susan Hansen - For Personal Use Only L-LINE MOTOR TRUCK SERVICE MANUAL Fig. 7 - Detai Is of governor. FUEL SYSTEM Section D Page 5 Spinner or rotor housing is located at distributor, mechanical governor without resorting to lengthy and complicated linkage. The governor can be cleaned and serviced without the use of s})ecial tools, The governor is made up of two units (see Fig. 7). The control at the engine end of the governor consists of a governor valve (47), an adjusting screw (48) and a spring (49) assembled i:r: a rotor (41) which revolves at one half the eng~ne speed, in a housing (52), attached to an engme driven shaft (43). The controls at the carburetor end of the governor unit consist of a diaphragm (35) which is connected to the goverl1or lever (45) by a short rod and a tension spring (46) which is also attached to the governor lever (45) and tends to hold the throttle open. The diaphragm chamber (33) in Fig. 9 is con 'nected to the governor valve air bleed orifice (50) in Fig. 7 by means of a c onve ntional pipe line (34). The air bleed supply enters the rotor housing (52), Fig. 7, from a pipe line (42) at. tached to the engine air cleaner or carburetor as shown in Fig. 7. Vacuum to the diaphragm (33), Fig. 7, is sup plied by means of the two channels (37) ,and (38) as shown in Fig. 8. Channel (37) opens mto the carburetor above the throttle plate and channel (38) below the throttle plate. These two openings are connected by channel (29), Fig. 8, which in turn is directly connected ~o channel (36) as shown in Fig. 9. The vacuum 1S controlled by the governor by-pass channel jets (39) instead of the variable restriction formerly used. A detailed description and the operation of the above mentioned features follows: Governor Operation 54 38 53 Fig, 8 PRINTED IN UNITED STATES OF AMERICA A-22240 When the engine is running at idling speed, the throttle is controlled by the external lever (2), Fig. 8, and the pin (54) which is held against the internal lever (53) on the throttle shaft by the accelerator spring, as shown in Fig, 8. At idling speed, the governor valve (50) in Fig. 7 is held away from the air bleed orifice (50) by the spring (49) which is fastened to the governor adjusting screw (48). As the accelerator is