Download Fuel System - Hansen Web Design

Transcript
Donated by John & Susan Hansen - For Personal Use Only
L-LINE MOTOR TRUCK SERVICE MANUAL
Fig. 7 - Detai Is of governor.
FUEL SYSTEM
Section D
Page 5
Spinner or rotor housing is located at distributor,
mechanical governor without resorting to
lengthy and complicated linkage. The governor
can be cleaned and serviced without the use of
s})ecial tools,
The governor is made up of two units (see Fig. 7).
The control at the engine end of the governor
consists of a governor valve (47), an adjusting
screw (48) and a spring (49) assembled i:r: a
rotor (41) which revolves at one half the eng~ne
speed, in a housing (52), attached to an engme
driven shaft (43). The controls at the carburetor
end of the governor unit consist of a diaphragm
(35) which is connected to the goverl1or lever
(45) by a short rod and a tension spring (46)
which is also attached to the governor lever (45)
and tends to hold the throttle open.
The diaphragm chamber (33) in Fig. 9 is con­
'nected to the governor valve air bleed orifice
(50) in Fig. 7 by means of a c onve ntional pipe
line (34). The air bleed supply enters the rotor
housing (52), Fig. 7, from a pipe line (42) at.
tached to the engine air cleaner or carburetor
as shown in Fig. 7.
Vacuum to the diaphragm (33), Fig. 7, is sup­
plied by means of the two channels (37) ,and
(38) as shown in Fig. 8. Channel (37) opens mto
the carburetor above the throttle plate and
channel (38) below the throttle plate. These
two openings are connected by channel (29),
Fig. 8, which in turn is directly connected ~o
channel (36) as shown in Fig. 9. The vacuum 1S
controlled by the governor by-pass channel
jets (39) instead of the variable restriction
formerly used.
A detailed description and the operation of the
above mentioned features follows:
Governor Operation
54
38
53
Fig, 8
PRINTED IN UNITED STATES OF AMERICA
A-22240
When the engine is running at idling speed, the
throttle is controlled by the external lever (2),
Fig. 8, and the pin (54) which is held against the
internal lever (53) on the throttle shaft by the
accelerator spring, as shown in Fig, 8. At
idling speed, the governor valve (50) in Fig. 7
is held away from the air bleed orifice (50) by
the spring (49) which is fastened to the governor
adjusting screw (48). As the accelerator is