Download Maintenance Manual

D40x40 / Navtec Navigator Maintenance
CHANGE HYDRAULIC FLUID
Change hydraulic fluid and inspect strainer at
1000 hours.
NOTE: If the fluid smells burned, contains
air bubbles, or appears contaminated,
consult Vermeer dealer immediately.
IMPORTANT: Hydrostatic systems require
absolutely clean fluid. Any dirt, water, sand, or
other contaminants allowed into hydraulic lines or
fittings could cause complete failure of a pump or
motor.
EN-OM-5506-FE95
•
Run engine until it reaches operating
temperature to warm hydraulic fluid before
draining. Follow shutdown procedure.
•
Remove fill cap # 1 .
NL01096.H95
: if
EN-OM-2726-OC93
Maintenance -1000 Service Hours
(35-2)