Download On-Line Technical Training Course

Transcript
Service & Parts Education
4-POLE DC MOTOR BRAKE COIL REPLACEMENT
(continued)
4. Begin to disassemble the motor connector by removing
the roll pin at the top of the connector. Then remove the
two screws and clamp at the base of the connector.
5. Slide the Anderson housing back to expose the
individual motor and brake connectors. The red and
black connectors are for the motor, and the two black
connectors are for the brake. You will need to separate
the individual housings from the contacts (as shown in
the picture to the right). The new brake coil will have
new contacts already crimped to the wire leads.
6. Upon completing step 5, slide the Anderson housing
off of the motor lead, and remove the protective sleeve
to expose the wires coming out of the motor housing.
Caution
Do not cut this protective cover, slide it off of the
wires unless you have replacement protective
covering for the wires. If you are cutting off the
protective covering, be careful not to damage the
original motor wiring. If you do cut into the
insulation of the motor wiring, it must be
repaired before putting the protective covering
back onto the wiring.
Power Mobility Guide
Rev. 1/09 TER
2-12