Download On-Line Technical Training Course
Transcript
Service & Parts Education 4-POLE DC MOTOR BRAKE COIL REPLACEMENT (continued) 4. Begin to disassemble the motor connector by removing the roll pin at the top of the connector. Then remove the two screws and clamp at the base of the connector. 5. Slide the Anderson housing back to expose the individual motor and brake connectors. The red and black connectors are for the motor, and the two black connectors are for the brake. You will need to separate the individual housings from the contacts (as shown in the picture to the right). The new brake coil will have new contacts already crimped to the wire leads. 6. Upon completing step 5, slide the Anderson housing off of the motor lead, and remove the protective sleeve to expose the wires coming out of the motor housing. Caution Do not cut this protective cover, slide it off of the wires unless you have replacement protective covering for the wires. If you are cutting off the protective covering, be careful not to damage the original motor wiring. If you do cut into the insulation of the motor wiring, it must be repaired before putting the protective covering back onto the wiring. Power Mobility Guide Rev. 1/09 TER 2-12