Download SERVICE MANUAL

Transcript
2. The wattage of the 2 lamps is different.
Make sure that the lamp having the correct wattage is attached by aligning the
lamp with the holes on the heater lamp
bracket.
3. Do not directly touch the glass sections
of the lamps, and leave fingerprints or
other marks.
6
7
6
7
[H] Upper/lower heat roller and cleaning roller 3
(1) Remove the fuser unit guard and jam processing unit.
(2) Draw out the 2 heater lamps.
(3) Completely loosen the 2 screws fixing the pressure springs.
(4) Remove the front handle bracket (1 screw).
(5) Remove the front stop ring and gear.
(6) Remove the 2 front screws and take out the
bearing.
Bearing
Stop ring
(6)
(6)
(4)
Handle bracket
(7) Remove the timing belt.
(8) Remove the rear stop ring and take out the
pulley.
Stop ring
Timing belt
Pulley
6570/5570 FUSER UNIT
14 - 14
Mar. 1999 © TOSHIBA TEC